Table of Contents
Advertisement
3.5
Manage cables
Route your mains cord, antenna cable and all
other device cables through the cable holder
(1) at the back of the TV.
1
3.6
Insert the remote control
batteries
1.
Slide the battery cover off the back of the
remote control.
2.
Insert the two supplied batteries (Size AAA,
Type LR03). Be sure the + and - ends of the
batteries line up with the markings inside
the case.
3.
Slide the cover back into position.
Note:
Remove the batteries if not using the
D
remote control for an extended period of
time.
EN-10
3.7
Switch on the TV
The first time you switch on the TV, check that
the mains cord is properly connected. When
ready, then press POWER on the side of the
TV.
Note:
Certain TV models require you to
D
press and hold POWER for up to two
seconds. Your TV may take up to 15 seconds
to start.
3.8
First time setup
When you turn on the TV for the first time,
you are prompted to select the Country and
the menu Language.
If the menu is not displayed, press MENU to
display the menu.
1.
Press
Î and ï on the remote control
to select your country, and press OK to
confirm your choice.
2.
Press
Î and ï to select a language, and
press OK to confirm your choice.
The search starts automatically. All available
TV programmes and radio stations are
stored. This operation takes a few minutes.
If the transmitter or cable network sends
an automatic sort signal, the programs
are numbered correctly. In this case, the
installation is complete. Otherwise, use the
Channel setting menu to number the
programs.
Note:
To exit or interrupt the search, press
D
MENU. If no programme is found, consult
Section 9 Troubleshooting.
Hide quick links:
Advertisement
Table of Contents
