AGFA Drystar 5301 User Manual page 88

88 | Drystar 5301, Drystar 5302 | Basic Operation (operator mode)
8. Tear the plastic strip around the film pack.
9. Close the input tray.
2831F EN 20210601 1655
Note: The printer resumes printing as soon as the tray is
closed.
Note: Loading instructions are also available on the input
tray cover.
Note: Never load another film format when the input tray is
not empty. Intermediate changing of film formats increases
the risk for dust, which can damage the thermal print head
(TPH).
Note: The system performs an automatic calibration when
the film format has been changed.
Note: When a film job cannot be done because the tray to
which the job is assigned is empty, then the printer will
check if the films in the other tray can be used for this and
other print jobs in the print queue. The printer will skip the
print jobs that cannot be done and will resume them later.
Note: When a film sheet is inserted wrongly in the input tray,
then the printer will print on the back-side (non-emulsion
side). As a result, a film jam occurs.The operator will be
informed of this back side printing and will be asked to
remove the film jam and to check whether the loading
procedure was followed correctly.