Table of Contents
Advertisement
Stroke and damping via screws (M) and (N):
• The stroke adjustment (up to a maximum of 75 mm) of the bridge in
relation to the table is done with the screw (M) shown in Figure 6.
Adjust the damping of the bridge with the screw (N):
• To do this, lift the bridge manually from the table and let it fall. If it
drops too abruptly or stops before it is at table height, adjust the bal-
ance spring setting with screw (N). The screw is accessed through the
opening (5) shown in Figure 7.
- Turn screw (N) clockwise less →Spring thrust decreases
- Counterclockwise → Spring thrust increases (more damping)
Note: This setting may also be necessary in the event of major
changes or fluctuations in the room temperature.
6
Components and Controls
1
2
Figure 7: Components & controls
7
Safety
The following safety instructions refer explicitly to the TX MATIC planer bridge guard. For safe
working with the bridge guard, all safety instructions in the operating manual of your machine
must also be observed.
Residual Risks
The TX MATIX bridge guard corresponds to the latest state of the art and has been manufactured in accordance
with the recognised technical safety regulations. Nevertheless, due to the design determined by the intended
use of the machine/protective equipment, the following residual risks can still occur even when used as intended
and despite compliance with all relevant safety regulations:
Danger of clothing being drawn in by moving and rotating machine parts or tools.
Danger of crushing on workpiece guides and moving machine parts.
Risk of injury from flying tool parts in the event of tool breakage.
Therefore, generally wear protective goggles.
Risk of injury from flying workpiece parts and chips, splinters and dust coming out of the
machine. Therefore, generally wear protective goggles.
Increased noise emission. Therefore always wear hearing protection.
Increased dust emission. Use an extraction unit and/or wear a dust mask.
BA_ST_TX-MATIC_EN_08-22.docx
3
4
5
Figure 6: Stroke and damping
TX MATIC - Components:
(1) Protection bridge
(2) Lever for locking
(3) Wheel unit
(4) Hinge for bridge joint
(5) Opening to the balance spring
adjustment screw for lowering
6
Advertisement
Table of Contents
