Table of Contents
Advertisement
3
Intended Use
•
The guard may only be used on machines that comply with the specified standards. It may also only be
used on machines for which the machine manufacturer expressly permits its use.
•
These operating manual only applies in conjunction with the operating instructions of the machine on
which this protective device is to be mounted.
•
In particular, the information on intended use and the information on safe working practices given in
the operating instructions for the machine must be observed.
•
The machine manufacturer who intends to mount this protective device on his machine must ensure
that the tests specified in EN 859, EN 861 and EN 940 in the annexes have been carried out and passed
for the machine.
•
Any other use is considered improper and is prohibited. The manufacturer of this bridge guard accepts
no liability for damage resulting from improper use.
•
This bridge guard may only be attached to the machine, used and repaired by qualified and sufficiently
instructed personnel.
•
In particular, both the operating manual for the bridge guard and the operating instructions for the
machine must be observed and complied with.
•
Only original spare parts from the manufacturer may be used. The manufacturer of the safety guard
accepts no liability for damage caused by improper handling or unauthorised use of spare parts from
other manufacturers.
Conversions and Modifications of the Guard
Conversions and modifications to the bridge guard are strictly prohibited for safety reasons. This
will invalidate the CE declaration of conformity! The manufacturer is not liable for any resulting
damage. The risk for this is borne solely by the operator/user.
Dimensions
Figure 1: Dimensions
BA_ST_TX-MATIC_EN_08-22.docx
A = F + G
F
520
260
660
260
800
400
G
260
400
400
4
Advertisement
Table of Contents
