Table of Contents
Advertisement
1
General
The purpose of this operating manual is to acquaint the user with the TX MATIC bridge guard and enable him to
use it to the full extent of its intended capabilities. Observance of this manual helps to avoid dangers, to reduce
repair costs and downtimes and to increase the reliability and service life of the product. Furthermore, this doc-
ument serves to supplement instructions based on national regulations for accident prevention and environmen-
tal protection.
This operating manual must always be available at the place of use of the machine. It must
be read and followed by every person who is assigned to work on the machine.
The manufacturer accepts no liability for damage and malfunctions resulting from failure to observe the operat-
ing instructions or improper handling.
Apart from the operating manual and the legally binding accident prevention provisions applicable in the country
and place of use, the recognized technical regulations for safe and proper work must also be observed .
Versions
The bridge guard is available in two different versions:
1. for planing width 410 + 510 mm with two-part cover 420 + 320 mm Art. No. 3412
2. for planing width 630 mm with two-part cover 550 + 320 mm
The plate required for fastening to the machine is included in the scope of delivery (without screws).
Features
•
Bridge guard with two-part and fold-down cover for surface planers and combined surface planing and
thicknessing machines
•
With spring-loaded contact pressure onto the workpiece in height and lateral position via wheel unit
•
The wheel unit raises the guard to workpiece height
•
Once the workpiece has been pushed through, the guard lowers back to its original position
•
Optimum cutter block coverage is guaranteed
•
The wheel unit can be rotated horizontally, vertically and to 45°.
This ensures the required pressure on the machine table and fence.
Fulfilled Standards
The bridge guard, certified by the "BG-Holz" (German Wood Trade Association), is used to cover the cutter
block in front of the fence for woodworking machines in accordance with the following standards:
•
EN 859 Surface Planers & Jointers,
•
EN861 Surface Planers & Thicknessers,
•
EN4940 combined machines
•
and in accordance with the Machinery Directive 2006/42/CE
2
Check Delivery Conditions
Check the package for completeness and possible transport damage. In case of transport damage, please keep
the packaging and inform the shipping company and the manufacturer immediately! Also check whether the
scope of delivery corresponds to your order. Later complaints cannot be accepted.
Dispose of the packaging material in an environmentally friendly manner!
BA_ST_TX-MATIC_EN_08-22.docx
Art. No. 3413
3
Advertisement
Table of Contents
