When Installing On Ceiling - Toshiba IK-WB21A Advanced User's Manual

Installing the Camera (Cont.)
Some provided parts are required for installing the camera.
● When installing on ceiling
･ Ceiling attachment
･ Cover for mounting on ceiling
Important
Improper installation may cause the camera to fall.
●

■ When installing on ceiling

1
Make a hole in the ceiling where the camera is to be
installed to insert the AC adapter cable, LAN cable
and other cables.
2
Feed the AC adapter cable, LAN cable and other
cables through the hole.
3
Mount the ceiling attachment below the drilled hole.
･ Mount on a ceiling or other structure by securely fastening the four
corners of the attachment by four wooden screws.
･ Install securely on the ceiling where the ceiling is supported by a
beam.
･ If a beam cannot be found, put a support behind the ceiling to
prevent falling of the camera.
･ Mount the camera with the lens pointing in the direction of the
arrow on the ceiling attachment.
Ceiling Attachment
Wood Screw
18
Groove for passing
the AC adapter cable
and LAN cable.
Important
Check if the ceiling structure and material have a sufficient strength
●
before installing the camera onto a ceiling. If the amounting strength is
inadequate, the camera will fall, potentially causing an injury or a camera
failure. The wooden screws supplied as accessories do not provide an
adequate strength with some ceiling materials. For example, special
anchors are needed if the ceiling material is gypsum boards.
Please consult the building architects regarding ceiling structure and
strength.
4
Tie the safety wire of the ceiling attachment onto
the safety hook of the camera.
Hook
5
Connect the AC adapter cable, LAN cable and other
cables to the terminals on the camera.
LAN cable
AC adapter cable
19