N E M E S I S
15.
16.
Epoxy
Attach the speed control to the side of
the motor box using two-sided tape
and tie wraps. Connect the appropriate
leads from the speed control to the mo-
tor. Make sure the leads will not interfere
with the operation of the motor.
17.
Speed control
22
180mm
Balsa stick
Instruction Manual.
18.
19.
INSTALLING THE SPINNER
- Install the spinner backplate, propeller
and spinner cone.
1.
The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
Battery