Installing The Fuselage Servos - Seagull Models NEMESIS Assembly Manual

INSTALLING THE FUSELAGE SERVOS

Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Install the rubber grommets and brass
collets into all servos. Test fit the servos
into the fuselage servo mounts.
Secure the servos with the screws
provided with your radio system.
1.
Throttle servo
2.
3.
.
.
Rudder servo
THROTTLE SERVO ARM
INSTALLATION
Install adjustable servo connector in the
servo arm as same as picture below:
1.
2.
Throttle servo arm
Minimum servo spec.
Torque : 6.0V: 192.4 oz-in (13.8 kg-cm)
7.4V: 350.0 oz-in (25.2 kg-cm)
3.
Rudder servo arm
11