Buffalo DC319-P Assembly, Installation And Operation Instructions page 9

Installation
THIS APPLIANCE AND ITS INDIVIDUAL COMBINATION GAS VALVE MUST BE CONNECTED FROM
THE GAS SUPPLY PIPING SYSTEM DURING ANY PRESSURE TESTING.
Connect the gas supply directly to the 3/4"male BSP connector located near the lower left rear corner of
the fryer. When tightening the supply pipe, be sure to hold the mating connector extending from the unit
securely with a wrench. This will prevent any damage or distortion to the internal piping and controls of
the unit.
After connecting the gas supply, check again that the fryer is level. Use along spirit level four ways;
across the front and rear of the fryer pot, and along each edge.
Commissioning
1. Before leaving the new installation;
a. Check the following functions in accordance with the operating instructions specified in the
'Operation' section of this manual.
• Light the Pilot Burner.
• Light the Main Burner.
• Turning 'Off' the Main Burner/Pilot.
b. Ensure that the operator has been instructed in the areas of correct lighting, operation,
and shutdown procedure for the appliance.
2. This manual must be kept by the owner for future reference and a record of the Date of Purchase,
Date of Installation and the Serial Number of the Appliance must be recorded and kept with this
manual. (These details can be found on the Rating label which is located behind the fryer door.).
NOTE: If for some reason it is not possible to get the appliance to operate correctly, shut off the gas sup-
ply and contact the supplier of this appliance.
!
CAUTION
9