Ornamental Ring A Or Barrier Assy Replacing Method - Sony DSC-HX10 Service Manual

1-9. ORNAMENTAL RING A OR BARRIER ASSY REPLACING METHOD

Removal
Turn on the power and pull out the lens to set it in the TELE end state.
1
Remove the battery.
2
Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown in the figure below.
3
Turn the Ornamental Ring A clockwise and counterclockwise to detach it.
4
Tweezers
Solvent
A
Release the four claws to detach the Barrier Assy.
5
Claws
Barrier Assy
Installation
1 Attach the Barrier Assy while inserting the lever into the hole and locking the four claws.
Barrier Assy
Lever
Hole
Attach two Barrier Tapes so that the end of each tape comes to the dent.
2
Note: Attach Barrier Tapes carefully so that they do not wrinkle.
Attach the Ornamental Ring A and push it gently.
3
Barrier Tapes
Barrier Tapes
Dent
DSC-HX10/HX10V_L2
Ornamental Ring A
Claws
Barrier Assy
Ornamental Ring A
Dent
Creation of Naruto Gear jig
Prepare a Naruto Gear Lubricated Assy ( A-1802-347-A ) and a fine-tipped screwdriver (or thin stick such as
bamboo skewer). Insert a fine-tipped screwdriver (or thin stick such as bamboo skewer) into the Naruto Gear hole
and fix the Naruto Gear and the screwdriver with bond or equivalent.
Fine-tipped screwdriver.
(or thin stick such as bamboo skewer)
Naruto Gear Lubricated
Assy
(A-1802-347-A)
Hole
Note:
Handling of 1G-2G Lens and washers
Detach the 1G-2G Lens as little as possible.
If it is detached, install the washers with their projections set to the original positions.
When attaching the 1G-2G Lens, match the projection of the 1G-2G Lens with the groove
near the mark A and then tighten three screws in the order of mark A
3
1
Projection
Groove
Mark A
1-10
Fix with bond or
equivalent.
mark B mark C.
2
1G-2G Lens
Washer
Projection
Projection
Washer
Mark C
Mark B