Final Inspection - Sony DSC-HX10 Service Manual

Apply solder at two points and insert the two sensors into the Gear Case Assy.
wa
Install the FG Plate Spring while locking the claw and the boss.
ws
Install the Gear Case Assy to the camera body and tighten a screw.
wd
*Tightening torque = 0.05 ± 0.01 N.m (0.51 ± 0.1 kgf cm)
wf
Gear Case Assy
Screw
Solders
Boss
FG Plate Spring
Claw
Lands
Flexible board
Sensors
Clamp the Flexible Board with the groove, claw, and boss.
wg
Connect the Flexible Board to the connector.
wh
Groove
Flexible board
wj Attach the Flexible Board Retainer by inserting the projection and then locking the claw.
Claw Hole
2
Flexible Board Retainer
1
Projection
Hole
DSC-HX10/HX10V_L2
Lands
Flexible board
Sensors
Boss
Claw
Flexible board

1-11. FINAL INSPECTION

1-11-1. Confirm There is No Fault in Actual Motion/Actual Screen
Inspect it as follows when you exchange parts in the lens block.
Zoom motion (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
1
No abnormal sound or motion must be found over full stroke between TELE end and WIDE end.
Zoom image
2
No abnormality such as a skipped image or wavy image must be found in the image through LCD or finder over full stroke between
TELE end and WIDE end.
Barrier (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
3
The barrier must be opened and closed fully, free from a sticking in the midway.
No abnormal sound must be heard during the operation.
Appearance condition Scratches or stains must not be noticeable, except that the customer permits them.
4
Foreign matters on the lens The lens condition must not be worse than that when the camera was received from the customer.
5
Lens at WIDE end
Full stroke check
Lens at TELE end
1-16
Upward
Horizontal
Downward