Ipod Adaptors - Technika MC-121IDAB Owner's Handbook Manual

iPod ADAPTORS

Before docking your iPod you must first check if your iPod
has a docking connector. Early iPod models do not have one
and cannot be docked to your unit. The docking connector is
located on the base of the iPod as shown below.
Docking Connector
Before docking your iPod, you must first fit the correct iPod
adaptor to the docking bay. Each iPod adaptor matches the
shape of a particular iPod and is necessary to ensure that
your iPod is securely held when docked.
iPod adaptor
Docking bay
FITTING THE iPod ADAPTOR
When your iPod was new it may have been supplied with a
standard dock adaptor in the packaging. If so, refer to the
next page for instructions to open the iPod dock and press
the adaptor gently into the Docking Bay as shown above.
NOTE: Do not dock an iPod without fitting the correct adaptor,
you may damage the iPod and your unit.
FINDING AN ADAPTOR
If you don't have a dock adaptor
If your iPod was not supplied with a standard dock adaptor,
or if you have lost the adaptor, you can buy one from Apple
on-line. To determine the exact model of your iPod, refer to
this web-link - http://support.apple.com/kb/HT1353. You
can then browse the iPod accessories page on the Apple
website to find an adaptor for your iPod model that can be
purchased on-line.
15
CONNECTING OTHER iPod
MODELS (INC SHUFFLE)
If you own an iPod Shuffle, a model without dock connector
or prefer to connect your iPod by cable, you can connect the
sound output to the Aux/Line In jack on the side panel.
Headphone socket
To the Aux In jack
• Using a 3.5mm stereo jack to jack cable (not supplied),
connect one end of the cable to the headphone socket of
the iPod, and the other end to the Aux/Line In jack on the
back panel.
• To listen to your iPod, follow the instructions on page 18
for playing equipment connected to the Aux In jack.
NOTE:- The volume control of the iPod must be turned up
when playing through the Aux/Line In jack.