Advertisement
INSTALLATION
1. Install the half door inside the enclosure.
2. Refer to the shower instructions for how to install the weather bar and the shower.
1. 半门安装在淋浴房内部。
2. 挡水条和淋浴房安装， 参考对应淋浴房说明书。
1. Cover the lock seat with water diveter on the bolt and press it tightly against the wall.
Mark the position with a pencil.
2. Drill a hole and install the hollow wall anchor by reference to step 1.
3. Install the lock seat with water diveter.
4. Cover the lock seat with water diveter on the bolt and press it tightly against the weather
bar. Mark the position with a pencil. Drill a hole and install the hollow wall anchor. Then
install the lock seat.
1. 将靠墙门栓座套入插销， 紧靠墙壁， 用笔标记好位置。
2. 参考第一步方法钻孔， 装膨胀套。
3. 安装靠墙门栓座。
4. 将靠挡水条固定座， 套入插销， 紧靠挡水条， 用笔标记好位置， 然后钻孔， 装膨胀套， 再安装好
固定座。
1386867-T01-A
安装
1. As shown in the figure below, install the door glass 20 mm above the ground and make
sure the end surface of the hinge, after being opened, presses tightly against the weather
bar (or the wall jamb if no weather bar is present) and its rear presses against the wall.
2. Use a level to make sure that the end surface of the half door hinge is perpendicular to the
ground.
3. Mark the screw holes with a pencil as shown in the figure below. Then drill holes and
install the hollow wall anchor into the wall.
4. Fix the half door onto the wall.
1. 参考下图， 门玻底部距离地面20mm， 铰链打开端面紧靠挡水条 （没有挡水条的紧靠墙材） 背面
靠墙壁。
2. 用水平仪测量， 使半门铰链端面与地面垂直。
3. 参考下面方式， 用铅笔标记螺钉孔位置， 然后钻孔将膨胀套装入墙壁。
4. 将半门与墙壁固定。
0mm
IMPORTANT:
Tray MUST be level
along front edge.
重要：
底盘必须水平。
STEP
1
1. Apply sealant around the lock seat of the bolt.
1. 插销固定座周围打胶。
STEP
3
-3-
0mm
The wall jamb
must be kept
vertical.
上墙材必须垂直。
6mm
The surface indicated by the arrow
presses tightly against the curb
箭头所指平面紧靠挡水条
STEP
2
STEP
4
Advertisement
