Optional Connections; Wi-Fi Antenna; Ethernet; Auxiliary Controller Area Network (Canbus) Interface - Raven Viper 4 Installation Manual

Chapter 5

Optional Connections

Wi-Fi Antenna

Connect the supplied wi-fi antenna to the coaxial receptacle labeled "8" to allow the Viper 4 to use a wireless
connection point or hot spot. Refer to Figure 3 on page 7.

Ethernet

An ethernet adapter cable is required for the Turck receptacle labeled "3" to connect the Viper 4 to a Slingshot
Field Hub to receive RTK corrections. Refer to Figure 3 on page 7.
The adapter cable may also be used to connect the Viper 4 with an ethernet enabled device such as a wireless
modem.

Auxiliary Controller Area Network (CANbus) Interface

In addition to Raven CANbus systems, the Viper 4 is capable of interfacing with ISOBUS systems and
networks using the J1939 protocol. This capability allows the Viper 4 to interface with several systems installed
by the original equipment manufacturer. Contact a local Raven dealer or an equipment service center for more
information and purchasing.
Connect the auxiliary CANbus cable to the Conxall receptacle labeled "5" to connect the Viper 4 to auxiliary
CANbus systems.
24 Viper 4™ Installation Manual