Mounting The Field Computer; Orientation; Mount The Field Computer - Raven Viper 4 Installation Manual

Chapter 4

Mounting the Field Computer

Read and perform the following steps to use the provided RAM
Viper 4 field computer.

Orientation

The Viper 4 may be mounted in either a portrait or landscape orientation to best suit field operations, operator
needs, and implement cabin space.
Raven Viper 4 Field Computer with Raven OS
FIGURE 1.
Note:
When mounted in portrait orientation, the Viper 4 power button must be in the lower, right corner of
the device.

Mount the Field Computer

Note:
If a CAN switch box or Switch Pro will be installed with the Viper 4 field computer, use the
mounting hardware provided with the switch box. Refer to the switch box installation guide for
assembly and mounting instructions.
Loosen the RAM socket arm and remove the circular base.
1.
Mount the circular base to a flat surface within the operator's cabin or compartment.
2.
Place the square base over the mounting posts on the back of the Viper 4 console.
3.
Note:
The ball on the square base is offset to provide additional clearance or mobility of the console. The
base may be oriented with the ball toward either the top or bottom of the console as necessary or
desired for the selected mounting position.
Use the provided flat washers, lock washers and screws to secure the square base to the back of the Viper
4.
4 console.
Replace the RAM socket arm onto the circular base and tighten the arm to secure the console.
5.
Adjust the console as necessary for optimal viewing and operation.
6.
Note:
It is normal for the case to become warm to the touch during Viper 4 operation.
18
®
mount and hardware to mount and secure the
Viper 4™ Installation Manual