Installation Overview And Kit Contents; Overview Of The Installation Process - Raven Viper 4 Installation Manual

CHAPTER
3

Overview of the Installation Process

The information provided in this manual is intended to cover basic installation of the Raven Viper 4™ and
components supplied with device. The following procedures are recommended to complete installation of the
Viper 4 and control systems:
Review Chapter 3, Installation Overview and Kit Contents and verify necessary components are on hand
1.
before starting the installation process.
Review to Chapter 4, Mounting the Viper 4 for details on mounting the Raven OS device.
2.
Mount and connect GPS antenna (integrated receiver) or install external GPS components. Review the
3.
DGPS Antenna Mounting Recommendations section on page 19 for assistance with mounting the GPS
antenna.
Install any optional CANbus components.
4.
Route and connect chassis and console cabling. Refer to Chapter 5, Viper 4 System Connections.
5.
Connect power leads to vehicle battery.
6.
Note:
Review the Raven CANbus Network Installation Manual for additional information on building a
CAN (Controller Area Network) system. For instructions on installing additional or optional
hardware with the Viper 4, refer to installation documentation provided with the additional or
optional component(s).
Manual No. 016-0171-559 Rev. A
I nstallation Overview
C h a p t e r 3
and Kit Contents
13