White Rodgers Emerson Blue Wireless Easy Install 1F98EZ-1621 Installation Instructions Manual page 11

TROUBLESHOOTING
‡„‘‘–‹‰ ‹”‡Ž‡•• ‡˜‹…‡•
If the system does not operate or communicate properly using
the previous troubleshooting page, follow the steps below. This
procedure removes and reconnects all wireless devices in the
system to assure communication.
Remove Wireless Devices
1. At the Comfort Interface, press Menu button once.
2. Press the Connect button.
3. Press and release the ‡š– button until the display shows the
device you want to delete, CTL, RS 1, RS 2, RS 3 or ORS.
CTL (Equipment Control Module )
RS 1 (Indoor remote sensor 1)
RS 2 (Indoor remote sensor 2)
RS 3 (Indoor remote sensor 3)
ORS (Outdoor remote sensor 4)
RAS (Return Air Sensor - do not delete)
4. Press and hold the
and
delete each device. Press ‡š– until the display shows the
next device to delete.
5. Press the Run button to exit the menu.
buttons simultaneously to
†† ‹”‡Ž‡•• ‡˜‹…‡•
1. Power the device.
2. Go to “—‹’‡– ‘–”‘Ž ‘†—Ž‡ and press the Connect
button. “—‹’‡– ‘–”‘Ž ‘†—Ž‡ –ƒ–—• 
green indicating searching for wireless devices.
3. Press the Connect button on the device you want to add.
‘ ” ‹”‡Ž‡•• ‡˜‹…‡• ƒ”‡ ‘—‹…ƒ–‹‰
1. Using the Comfort Interface, press the Menu button once.
2. Press the Connect button once and release. Comfort Interface
will display (CTL) control and wireless icon.
3. Continue pressing and releasing the ‡š– button to view all
connected and communicating wireless devices. They will
appear in the following order to a maximum of:
CTL (Equipment Control Module)
RS 1 (Indoor remote sensor 1)
RS 2 (Indoor remote sensor 2)
RS 3 (Indoor remote sensor 3)
ORS (Outdoor remote sensor 4)
RAS (Return Air Sensor)
™‹ŽŽ ƒ•Š
11