Gumdrop BumpTech Installation Manual

1
Slide the device keyboard under the bottom case's
left side clip.
4
Close the device screen and carefully press the
rear corner clips to snap onto the keyboard.
7
Close the case and press on the rear clips along the back
edge of the top case. Make sure all clips are securely
attached. *Case may have a 3rd clip at the center
GumdropCases.com
2
Press the other side of the keyboard down
to snap into the right side clip securely.
5
Align the top edge of the device with the case's
upper side clips. Slide the top case down until the
device is flush with the top edge.
Congratulations on your new case!

INSTALLATION

3
Slide the keyboard forward until it is flush
with the front edge of the case.
6
Press the lower side clips over the device,
with pressure from both sides, to snap
into place securely.
BumpTech