Startup / Operation - BOMANN KB 7245 Instruction Manual

 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
 Ask another person to assist.
You possibly need:

driver as well as a thin-blade screwdriver.
 Remove the blind cap (1) and the hinge cover (2).
 Dismount the upper door hinge (4) by loosening
the screws (3). Open the appliance door a little
and lift it out of the lower door hinge.
 Place the appliance door safely aside.
 Tilt the appliance slightly backwards and block it
in this position. Unscrew the foot (7).
 Dismount the lower door hinge (5) by loosening
the screws (6).
 Displace and attach the door hinge (5) at the op-
posite appliance side. Turn in the foot (7) accord-
ingly.
 Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
screw wrench, Phillips screw-
 Displace and attach the upper door hinge (4) at
the opposite appliance side.
 Insert in the blind cap (1) at the opposite hole and
put on the hinge cover (2) again, which you have
removed at the beginning.
Check if the door is aligned vertically and horizontally
optimally so that the smooth opening and closing of
the door is guaranteed.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance
 Connect the appliance to the power supply.
 Operate the temperature control. See also the
section "Settings".
Settings
Setting [ OFF ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ MIN – MAX ] regulate the different
values of the internal temperature.
Setting OFF: Off state
Setting MIN: Lowest setting (warmest inside temp.)
Setting MAX: Highest setting (coldest inside temp.)
18