Appliance Equipment; Installation - BOMANN GB 7246 Instruction Manual

NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter "Cleaning and Maintenance".

Appliance Equipment

Appliance overview
1 Temperature control
2 Glass shelf
Delivery scope
Ice-cube tray

Installation

Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
- Gap to the back approx. 50～70 mm, to the
side walls and above the device each approx.
min. 100 mm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
3 Appliance door
The climate class can be found under "Technical
Data" and on the rating label located in the interior
or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
17