Bosch GDR Professional Original Instructions Manual page 9

OBJ_BUCH-608-002.book Page 9 Monday, November 23, 2009 8:32 AM
Cordless Impact Screwdriver
Article number
Rated voltage
No-load speed
Impact rate
Maximum torque, hard screwdriving applica-
tion according to ISO 5393
Bolt size
Tool holder
Weight according to EPTA-Procedure 01/2003
Please observe the article number on the type plate of your machine. The trade names of the individual machines
may vary.
Assembly
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cy-
cles.
To remove the battery 5 press the unlocking but-
tons 6 and pull out the battery downwards. Do
not exert any force.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Changing the Tool (see figure A)
Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Bosch Power Tools
GDS 12 V GDS 14,4 V
Professional Professional
0 601 909 K.. 0 601 909 H.. 0 601 909 F..
V= 12
-1
min 0 –2800 0 –2800
-1
min 0 –3200 0 –3200
Nm 175
mm M6 – M14 M6 – M16
½"
kg 1.8
GDR 9,6 V/GDR 12 V/GDR 14,4 V/GDR 18 V:
Inserting
Pull the locking sleeve 2 forward, push the in-
sert tool to the stop into the tool holder 1 and
release the locking sleeve 2 to lock the insert
tool.
Use only screwdriver bits with ball catch 11
(DIN 3126-E6.3). Other screwdriver bits 13 can
be used with a universal bit holder with ball
catch 12.
Removing
Pull the locking sleeve 2 forward and remove the
insert tool.
GDS 12 V/GDS 14,4 V/GDS 18 V:
When working with an application tool, pay
attention that the application tool is firmly
seated on the tool holder. When the applica-
tion tool is not firmly connected with the tool
holder, it can come loose again and not be
controlled.
Slide the application tool onto the square drive
of the tool holder 1.
English | 9
GDS 18 V
Professional
14,4 18
0 –2800
0 –3200
200 220
M6 – M20
½" ½"
1.9 2.2
1 609 929 T16 | (23.11.09)