Provision Esim - Honeywell CT45 Series User Manual

Note: On CT45 XP WWAN models with an eSIM instead of a second nano-SIM socket, the
eSIM is SIM 2. For more information, see
6. Close the SIM card access door.
7. Install the battery. Refer to
8. Follow your phone carrier instructions for activation and connection to a mobile

Provision eSIM

Follow these steps to provision the mobile computer if you are using the embedded
SIM (eSIM), available on supported CT45 XP models. On these models, the eSIM is
SIM 2.
To connect to a mobile network using eSIM, the eSIM must be provisioned by
downloading and enabling an operational profile. Mobility Edge devices use the
Thales LPA (Local Profile Assistant) app to download carrier profiles to the eSIM
and manage the downloaded profiles.
Mobile computers are enrolled by scanning a QR code. Contact your mobile carrier
to obtain the QR code and any other information required to activate the profile.
52
b. Optional - SIM 2 (model dependent): Slide the nano-SIM card into the
socket with contacts facing down.
network. By default, the nano-SIM card installed in SIM 1 is assigned to SIM
Slot 1, which is used for phone activation.
If you installed a second nano-SIM card in SIM 2, you must first use the SIM
Selection App to assign the SIM 2 card to SIM Slot 1 before you activate the
second card. For more information, see Assigning a SIM to SIM Slot 1 on page
49.
If both nano-SIM cards are activated, you can use them both in Dual SIM Dual
Standby mode. For more information, see Using Dual SIM Dual Standby Mode
on page 49.
Provision eSIM
Install the Battery
CT45/CT45 XP Mobile Computer Series User Guide
on page 52.
on page 8.