Table of Contents
Advertisement
Q: When I run in Dual Mode I seem to lose a little overall level. Why?
A: The effects you're using may be boosting the overall signal level (which you can test by hitting the
Internal Effects Bypass switch). If so, when you engage Dual Mode, you're taking one channel of the
unit and dropping its signal back down to the unaffected level. If you can achieve balance between your
clean and wet sounds before using Dual Mode, you should hear no difference when running in Dual
Mode.
Q: How come the MIDI Out isn't working?
A: The MIDI Out will only engage when the "Mo' Control 2" footswitch is in use, and a MIDI capable
external effects device is connected at both the MIDI Out (for MIDI control) and the stereo external
effects loop (for audio signal routing).
Q: Why do both Master Volume controls work when I'm using the mono main output to send
audio to my power amp?
A: Because the "left" and "right" channels go through a "summing" amp just before the Master section.
This occurs regardless of whether or not you are using the Dual Mode function.
Q: I want to slap with the Bassynth on, but it sounds like something is clipping or being over-
loaded no matter what I do. What's up?
A: The Bassynth on the Mini-Mo' Preamp is really designed for fingerstyle playing more so than for
slapping. That's because the circuit is a sawtooth wave generator, the same kind used on cop wough038 usedb7
s
s
l. lyou fee
Advertisement
Table of Contents
