SWR WORKINGMAN’S 4004 Owner's Manual
  1. Manuals
  2. Brands
  3. SWR Manuals
  4. Amplifier
  5. WORKINGMAN'S 4004
  6. Owner's manual

SWR WORKINGMAN’S 4004 Owner's Manual

Workingman’s 4004 amplifiers
Hide thumbs Also See for WORKINGMAN’S 4004:
Table of Contents

Advertisement

Quick Links

See also: Owner's Manual
WORKINGMAN'S 4004
OWNER'S MANUAL
OWNER'S MANUAL
SWR • SCOTTSDALE, AZ • USA

Advertisement

Table of Contents
loading

Related Manuals for SWR WORKINGMAN’S 4004

Summary of Contents for SWR WORKINGMAN’S 4004

  • Page 1 WORKINGMAN’S 4004 OWNER’S MANUAL OWNER’S MANUAL SWR • SCOTTSDALE, AZ • USA...
  • Page 2 SWR product. We truly hope that your purchase of an SWR helps bring out the best in your playing and adds to your enjoyment of music.
  • Page 3 If you hear a small amount of distortion and the Preamp Clip LED is not activated, try using the Active input jack. And please note, some passive pickups DO distort. Because of the hi-fi nature of all SWR products, even the smallest amount of distortion originating at the source (instrument) may be heard.

  • Page 4: Gain Control

    FRONT PANEL FEATURES (continued) FRONT PANEL FEATURES (continued) ACTIVE INPUT ACTIVE INPUT The Active input jack should be used with instruments having a built-in (on-board) preamp that will produce signals over 1 volt RMS. Known basses that should use the Active input only are the Kubicki X-Factor and some Ovation electrics.

  • Page 5: Bass Control

    FRONT PANEL FEATURES (continued) FRONT PANEL FEATURES (continued) TONE CONTROL SECTION TONE CONTROL SECTION The Workingman's 4004 Tone Control section is a five-band set of level slide controls centered around the frequencies 80 Hz (Bass), 160 Hz (Low Mid), 400 Hz (Mid), 800 Hz (Hi Mid) and 3KHz (Treble). Each control can cut or boost its band a maximum of 15dB.

  • Page 6: Master Volume

    FRONT PANEL FEATURES (continued) FRONT PANEL FEATURES (continued) EFFECTS BLEND CONTROL EFFECTS BLEND CONTROL The Effects Blend control mixes the signal coming from your instrument with the sound coming from your effect. With the Blend control fully counter-clockwise, no signal from your effect will be heard. As you turn this control clockwise, more of the effect can be heard in the overall sound.

  • Page 7: Power Switch

    Please Note: This switch does NOT affect the Headphone jack. Please Note: FRONT PANEL FEATURES (continued) FRONT PANEL FEATURES (continued) STEREO HEADPHONES JACK STEREO HEADPHONES JACK By inserting a set of stereo headphones into this jack you will be able to monitor your sound or practice without disturbing your neighbors.
  • Page 8 The total impedance of the speakers should be 4 Ohms or greater. This means you can use one 4 ohm cabinet, two 8 ohm cabinets or four 16 ohm cabinets. RECOMMENDED SPEAKER ENCLOSURES FROM SWR INCLUDE: RECOMMENDED SPEAKER ENCLOSURES FROM SWR INCLUDE: Workingman's 4X10T, Workingman's 1X15T, Goliath III, Son Of Bertha, and the Big Ben Subwoofer (you can use any two of these as they are all 8 ohms).

  • Page 9: Suggested Settings

    SUGGESTED SETTINGS SUGGESTED SETTINGS WORKINGMAN’S 4004 OWNER’S MANUAL • 8 WORKINGMAN’S 4004 OWNER’S MANUAL • 8...
  • Page 10 SUGGESTED SETTINGS (CONTINUED) SUGGESTED SETTINGS (CONTINUED) WORKINGMAN’S 4004 OWNER’S MANUAL • 9 WORKINGMAN’S 4004 OWNER’S MANUAL • 9...

  • Page 11: Limited Warranty

    ONE YEAR from the date of purchase, against defects in materials and workmanship and that it is purchased from an Authorized SWR Dealer. This warranty applies only to products purchased in the USA or Canada. This warranty is VOID if the unit has been damaged due to accident, improper handling, installation or operation, shipping damage, abuse or misuse, unauthorized repair or attempted repair, or if the serial number has been defaced or removed.

Table of Contents