Husqvarna BS 75 Operator's Manual page 17

To replace the blade
WARNING:
blades are very sharp.
1. Lift the front of the product and put a support below
the product. Make sure that the blade is lifted from
the floor.
2. Loosen the 3 screws on the tool holder.
3. Remove the blade.
4. Push the new blade into the tool holder.
5. Make sure that the blade is in the correct position.
6. Tighten the 3 screws on the tool holder.
To sharpen the blade
WARNING:
blades are very sharp.
1804 - 001 - 06.05.2022
Use protective gloves. The
Use protective gloves. The
1. Lift the front of the product and put a support below
the product. Make sure that the blade is lifted from
the floor.
2. Sharpen the blade with an angle grinder. Use a
grinding disc with a grit of 120.
WARNING:
grinding disc does not catch the edge or
corner of the blade.
a) Grind the top edge of the blade for bevel up.
b) Grind the bottom edge of the blade for bevel
down.
Make sure that the
17