Table of Contents
Related Manuals for Miele DAS 8630
Summary of Contents for Miele DAS 8630
- Page 1 Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 12 039 300...
-
Page 2: Table Of Contents
Description of the functions ................16 Before using for the first time ................17 Selecting extraction mode or recirculation mode..........17 Setting up Miele@home ..................17 Connecting via the App.................. 18 Connecting via WPS ..................19 Signing out of Wi-Fi (reset to factory settings) ..........20 Setting up Con@ctivity .................. - Page 3 Contents Cleaning and care ..................... 33 Housing ....................... 33 Important information for appliances with stainless steel surfaces ....33 Grease filters ....................... 34 Change grease filters..................35 NoSmell active charcoal filters ................36 Resetting the charcoal filter operating hours counter ........36 Disposing of the charcoal filters ..............
-
Page 4: Warning And Safety Instructions
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The rangehood cannot be used to ventilate the room in which it is installed in recirculation mode above a gas cooktop. - Page 5 Warning and Safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning its use by a person responsible for their safety, and are able to recognise the dangers of misuse.
- Page 6 Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage.
- Page 7 The lamps are a built-in component of the lighting. Replacement lamps may only be installed by a Miele authorised technician. During installation, maintenance and repair work, the appliance must be disconnected from the mains electricity supply.
- Page 8 Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Danger of toxic fumes! Great care should be taken when using the rangehood in the same room or the same area of the house as another heating appliance that depends on the air from the room.
- Page 9 Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by a heating appliance from being drawn back into the room, when the rangehood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
- Page 10 Warning and Safety instructions Correct use Open flames are a fire hazard! Never use an open flame under the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Kitchen grease deposits could ignite.
- Page 11 Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The rangehood can get very hot during cooking due to heat rising from the cooktop.
- Page 12 The steam could reach electrical components and cause a short circuit. Accessories and spare parts Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability. ...
-
Page 13: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packaging Electrical and electronic appliances has been selected from materials which often contain valuable materials. They are environmentally friendly for also contain specific materials, disposal, and can normally be recycled. -
Page 14: Guide To The Rangehood
Guide to the rangehood... - Page 15 Guide to the rangehood a Pull-out deflector plate b Grease filter c Control panel d Cooktop lighting e Exhaust connection f Charcoal filter Single-use or reactivatable charcoal filters Optional accessory for recirculation mode g Sensor for switching the rangehood on and off h Sensors for switching the fan on and off and for setting the fan power level i Sensor for the run-on function j Sensor for the grease filter operating hours counter...
-
Page 16: Description Of The Functions
Description of the functions Depending on the model of the Recirculation mode rangehood, the following options are (available as an optional extra with a available: conversion kit and charcoal filter: see “Technical Data”) Air extraction mode The air is drawn in and cleaned first by The air is drawn in and cleaned by the the grease filters and then by a charcoal grease filters and directed outside. -
Page 17: Before Using For The First Time
Pull out the deflector plate. App. Switch off the fan with the button 2 If your Miele cooktop is connected to a and the lighting with the button . home Wi-Fi network, you can control Press and hold the run-on option the rangehood automatically via the control ... -
Page 18: Connecting Via The App
Start the appliance registration in the App. Follow the login steps. Connecting via the App If requested to activate Wi-Fi on the The Miele App can be used to connect rangehood, proceed as follows: to your network. Install the Miele App on your mobile... -
Page 19: Connecting Via Wps
Before using for the first time Touch the On/Off sensor . Connecting via WPS All symbols light up with reduced Your Wi-Fi router must support WPS brightness. (Wi-Fi Protected Setup). Touch the On/Off sensor . All symbols light up with reduced ... -
Page 20: Signing Out Of Wi-Fi (Reset To Factory Settings)
With an existing Wi-Fi connection 2 and Useful tip: If your Wi-Fi router does not 3 will light up constantly. support WPS, please connect via the The rangehood is ready for Miele App. disconnection during the next two minutes. -
Page 21: Setting Up Con@Ctivity
Setting up Con@ctivity Con@ctivity is the direct communication Touch the 1 control. system between an electric Miele cooktop and a Miele rangehood. It enables the rangehood to operate automatically depending on the 2 will light up constantly, 3 will flash on operational state of a Miele cooktop and off. -
Page 22: Con@Ctivity Via The Home Wi-Fi Network (Con@Ctivity 3.0)
(Con@ctivity 3.0) connection (Con@ctivity 3.0) Prerequisites: Prerequisite: - Home Wi-Fi network - Wi-Fi enabled Miele cooktop - Wi-Fi enabled Miele cooktop If you do not have a home network, you can establish a direct connection Connect the rangehood and cooktop... -
Page 23: Reattempting The Connection
Before using for the first time Start the Wi-Fi connection on the cooktop. For further details, see the cooktop operating instructions. When successfully connected 2 and 3 will light up constantly. Quit connection mode on the rangehood by touching the run-on control . -
Page 24: Operation (Automatic Mode)
Operation (automatic mode) When Con@ctivity is active, the rangehood always operates in automatic mode (see “Before using for the first time – Setting up Con@ctivity”). If you wish to manually operate the rangehood, see “Operation (manual mode) – Cooking without Con@ctivity”. Examples for power levels 1 to B Reaction time Cooking with Con@ctivity... -
Page 25: Cooking Process
Operation (automatic mode) Cooking process Switching off For example, you switch on a cooking Switch off all cooking zones. zone at the highest power level to The rangehood fan will reduce its power heat a pan for frying. After approx. level in stages over the next few 10 seconds to 4 minutes, you then minutes and will then switch itself off. -
Page 26: Leaving Automatic Mode Temporarily
Operation (automatic mode) You can also operate the rangehood Leaving automatic mode manually for a complete cooking temporarily process. To leave automatic mode temporarily To do so switch the rangehood fan on during cooking: before the cooktop. Manually select a different power If the rangehood fan and the cooktop level, or have been switched off for at least 30... -
Page 27: Operation (Manual Mode)
Operation (manual mode) Cooking without Con@ctivity Selecting a power level (manual mode) For light to heavy cooking vapours and odours, select from power levels 1 to 3. The rangehood can be operated manually if: For short periods of cooking food with intensive vapours and a strong aroma, - the Con@ctivity function is not e.g. -
Page 28: Selecting The Run-On Time
Operation (manual mode) Selecting the run-on time Dimming/Switching the cooktop lighting on/off It is advisable to run the fan for a few minutes after cooking has finished. This You can switch the cooktop lighting helps to remove any lingering vapours on by pulling the deflector plate out and odours from the air. -
Page 29: Changing Settings
Changing settings Touch the On/Off sensor . All settings are made with the rangehood switched off. All symbols light up with reduced Pull out the deflector plate and switch brightness. off the fan and the lighting. Press and hold the run-on option control ... -
Page 30: Altering Or Deactivating The Charcoal Filter Operating Hours Counter
Changing settings Altering or deactivating the Deactivating Power charcoal filter operating hours management counter Keep in mind that deactivating this function may increase energy Charcoal filters are needed for consumption. recirculation mode. You can set the operating hours counter Activating/deactivating Power to suit the type of cooking you do. -
Page 31: Buzzer For The Sensors
Changing settings All the indicator lights will go out. If you do not confirm your selection of setting within 4 minutes, the rangehood will revert to the previous setting. Buzzer for the sensors When a function is selected with the sensors, a short buzzer will sound for confirmation. -
Page 32: Energy Saving Tips
Energy saving tips This rangehood operates very efficiently - Use the Con@ctivity function. The and economically. The following will rangehood will switch on and off help you to save even more energy automatically. The rangehood will when using it: select the optimum power level for the cooking you are doing, which - Ensure that there is sufficient ensures low energy consumption. -
Page 33: Cleaning And Care
Housing To prevent the surfaces from quickly becoming dirty again, we recommend General treating them with a stainless steel care product (available from Miele). The surfaces and controls are susceptible to scratches and Important for appliances with glass abrasion. -
Page 34: Grease Filters
Cleaning and care Removing the grease filter Grease filters When handling the grease filter, Fire hazard! be careful not to drop it. Oversaturated grease filters are a fire This can result in damage to the filter hazard. and the cooktop below. Clean the grease filters at regular Make sure you hold the filter securely intervals. -
Page 35: Change Grease Filters
If you notice any damage, replace the Ensure the spray arm is not grease filters. obstructed. You can obtain grease filters from Miele Use a standard household customer service (see end of these dishwasher detergent. operating instructions) or from your ... -
Page 36: Nosmell Active Charcoal Filters
Charcoal filters are available to order via After changing the charcoal filters, the the Miele online shop (see the end of operating hours counter needs to be this booklet for contact details) or reset. -
Page 37: Reactivatable Charcoal Filters
Cleaning and care Reactivatable charcoal filters Reactivatable charcoal filters are available for this rangehood. They can be used several times after being reactivated in the oven. Please follow the operating instructions supplied with the filter. Bend out the tab, e.g. with a screwdriver. -
Page 38: Service
Service Contact in case of fault In the event of any faults which you cannot remedy yourself, please contact Miele. You can book a Miele customer service call-out online at www.miele.com.au/service or www.miele.co.nz/service. Contact information for Miele can be found at the end of this booklet. -
Page 39: Installation
*INSTALLATION* Installation Before installation Installation materials Before installation, it is important to read the information given on the following pages as well as the “Warning and Safety instructions” at the beginning of this booklet. 1 exhaust connection for exhaust ducting 150 mm. Installation recommendations - To achieve optimum vapour extraction, the rangehood must be... -
Page 40: Installation Materials For Recirculation Mode
*INSTALLATION* Installation 6 screws, 4 x 15 mm 4 screws, M4 x 16 mm Installation plan See the installation plan for details on the individual steps involved in the installation of this appliance. Installation materials for recirculation mode You need the following optional accessories for recirculation mode. -
Page 41: Appliance Dimensions
*INSTALLATION* Installation Appliance dimensions Diagram 1: DAS 8630 in a 600 mm wide cabinet. The drawing is not to scale... - Page 42 *INSTALLATION* Installation Diagram 2: DAS 8930 in a 900 mm wide cabinet. The drawing is not to scale See diagram 1 for side view Footnotes for diagrams 1 to 2: a The mounting brackets are suitable for cabinets with wall thicknesses from 16 to 19 mm.
-
Page 43: Safety Distance (S)
*INSTALLATION* Installation d The wall unit can be fitted with a partition after installation. Slots for the grease filters, and with recirculation mode for the charcoal filters, must remain accessible. Safety distance (S) The minimum distances between the cooking surface of a cooktop (pan support(s) for gas models) and the bottom of the rangehood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance. -
Page 44: Adjusting The Vapour Shield
*INSTALLATION* Installation Adjusting the vapour shield Connection for air extraction When retracted, the deflector plate is Before installation, it is important held in place by magnets. to read the information given on the The retaining force of the magnets can following pages as well as the be adjusted. -
Page 45: Non-Return Flap
Vent flue If the exhaust air is ducted through an outside wall, a Miele wall vent or a Miele roof vent (available as an optional accessory) is recommended. These are fitted with an integrated non-return flap. -
Page 46: Silencer
Miele will not accept warranty claims ducting (e.g. traffic noise). For this for any functional defects or damage reason, the silencer must be positioned caused by inadequate ducting. -
Page 47: Electrical Connection
The protective measures extension cable or multi-socket provided in the domestic installation adapter. and in this Miele product must also be assured in their function and operation All electrical work must be carried out in isolated operation or in non-mains... -
Page 48: Technical Data
Technical data Fan motor 290 W Cooktop lighting 3 W Total rated load 293 W Voltage, frequency AC 230 V, 50 Hz Fuse rating 10 A Mains connection cable length 1.5 m Weight DAS 8630 15 kg DAS 8930 19 kg Optional accessory for recirculation mode For recirculation operation, you need the DUU 150 or DUU 151 kit and the DKF 31-P or DFK 31-R charcoal filters (reactivatable). - Page 51 183 Featherston Street Miele Experience Centre South Melbourne: Wellington 6011 206-210 Coventry Street South Melbourne, VIC 3205 0800 464 353 (0800 4 MIELE) Miele Experience Centre and Office Sydney: www.miele.co.nz 3 Skyline Place Frenchs Forest, NSW 2086 Miele Experience Centre and Office Brisbane:...
- Page 52 DAS 8630, DAS 8930 en-AU, NZ M.-Nr. 12 039 300 / 00...