Subscribe to Our Youtube Channel
Related Manuals for JWA CLAYTON 68412
Summary of Contents for JWA CLAYTON 68412
- Page 1 ASSEMBLY INSTRUCTION CLAYTON Coat Stand 68412 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
- Page 2 PRE-ASSEMBLY PREPARATION Before you start: 1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2. Take care when lifting. Product should be assembled as near as possible to the point of use 3. Ensure that you have all required contents for complete assembly 4.
- Page 3 PARTS LIST M8*30MM Coat Stand 1PC Board x 2...
- Page 4 STEP 1: Fold out the 2 legs of the coat stand ① and then insert the 2x boards, as shown below. STEP 2: Connect the coat stand ① with 2 x boards (2). Use bolt (A) and Allen Key (B). Tighten only until the bolt is a little firm in the thread, do not fasten completely.
- Page 5 STEP 3: Stand the unit on a level surface. Push down on the legs until it levels out. Once level go around in and fully fasten all the bolts from step 2. Do not over tighten, this may damage the product. ASSEMBLY IS COMPLETE...
- Page 6 SAFETY BRACKETS INSTRUCTIONS 1. Install Plastic Screw Anchor in the wall and attach one Mounting Plate to the anchors with the Large Screws. Make sure to attach the Mounting Plate into a stud. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws. 3.
- Page 7 PRODUCT CARE: To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp objects (knife, fork, etc.) directly onto your furniture as sharp objects may scrape and damage the finish. •...
Need help?
Do you have a question about the CLAYTON 68412 and is the answer not in the manual?
Questions and answers