JVC MPEG-2 Instruction Manual page 31

[Serial Port Data Length Alteration]
Command : ChangeSerialPortDataLength
Arguments : Data Length (7 or 8)
Example : ChangeSerialPortDataLength 8
Operation : Alters data length of serial port.
[Serial Port Parity Alteration]
Command : ChangeSerialPortParity
Arguments : 0_No Parity; 1_Odd; 2_Even
Example : ChangeSerialPortParity 1
Operation : Alters parity of serial port.
[Serial Port Stop Bit Alteration]
Command : ChangeSerialPortStopBit
Arguments : Stop Bit (1 or 2)
Example : ChangeSerialPortStopBit 1
Operation : Alters stop bit of serial port.
[Serial Port Flow Control Alteration]
Command : ChangeSerialPortFlowControl
Arguments : 0_None; 1_Xon/Xoff; 2_Hardware
Example : ChangeSerialPortFlowControl 1
Operation : Alters flow control of serial port. Flow control prevents omission of data at the serial port. However,
data transmission rate will be lowered as a result. Data may be lost as a consequence when an
excessive amount of data from the network passes through the serial port in the flow control mode.
[Destination IP Address]
Command : ChangeDestinationAddress
Argument : IP address enclosed in double quotation marks. Separate the decimal integers using periods when
entering the IP address.
Example : ChangeDestinationAddress "10.0.0.100"
Operation : Alters destination IP address for unicast. Destination address when transmitting data manually from
DM-NE300E. The destination IP address changes accordingly with the decoder using the RTSP
protocol when transmitting/receiving with the DM-ND300E decoder.
[Destination Port Number Alteration]
Command : ChangeDestinationPort
Arguments : Port Number (0~65535)
Example : ChangeDestinationPort 10000
Operation : Alters the destination port number for unicast. Destination port number when transmitting data manually
from DM-NE300E. The destination port number changes accordingly with the decoder using the
RTSP protocol when transmitting/receiving with the DM-ND300E decoder.
[Unicast TTL Alteration]
Command : ChangeUnicastTTL
Argument : TTL
Example : ChangeUnicastTTL 64
Operation : Alters the TTL (Time to Live) for unicast. TTL indicates how many times the packet can pass through
routers.
25