JVC MPEG-2 Instruction Manual page 30

12. More Details on Settings
[Data Protocol Alteration]
Command : ChangeDataProtocol
Arguments : 0_RTP; 2_MPEG Only (1 is used for special experiments. Do not specify as 1.)
Example : ChangeDataProtocol 2
Operation : Alters MPEG-2 data protocol to be stored in UDP.
[Auto Start Mode Alteration]
Command : ChangeAutoStart
Arguments : 0_OFF; 1_ON
Example : ChangeAutoStart 0
Operation : Alters the Auto Start mode. When Auto Start mode is turned on, data transmission will automatically
start upon startup of DM-NE300E. When in the Unicast mode, data will be transmitted to the destina-
tion address specified at ChangeDestinationAddress. When in the Multicast mode, data will be sent
to the destination address specified at ChangeMulticastAddress.
[Unicast / Multicast Selection]
Command : ChangeMulticastMode
Arguments : 0_Unicast; 1_Multicast
Example : ChangeMulticastMode 0
Operation : Switches between unicast and multicast modes.
[Multicast Address Alteration]
Command : ChangeMulticastAddress
Arguments : IP address enclosed in double quotation marks. Separate the decimal integers using periods when
entering the IP address. Select address between 224.0.0.0 and 239.255.255.255.
Example : ChangeMulticastAddress "225.0.1.1"
Operation : Alters destination address of multicast transmission.
[Destination Port Number Alteration]
Command : ChangeMulticastPort
Arguments : Port Number (0~65535)
Example : ChangeMulticastPort 10000
Operation : Alters destination port number of multicast transmission.
[Multicast TTL Alteration]
Command : ChangeMulticastTTL
Argument : TTL
Example : ChangeMulticastTTL 64
Operation : Alters TTL (Time to Live) for multicast. TTL indicates how many times the packets can pass through
routers.
[Selection of Stop Mode During Multicast]
Command : ChangeMulticastStopMode
Arguments : 0_Stop when all decoders stop; 1_Stop when Master Decoder stops; 2_Stop manually
Example : ChangeMulticastStopMode 0
Operation : Specifies stop mode during multicast transmission.
[Serial Port Baud Rate Alteration]
Command : ChangeSerialPortBaudrate
Arguments : Baud rate. Select any of the following:
110, 134, 150, 200, 300, 600, 1200, 2400, ,3600, 4800, 7200, 9600, 19200, 31250, 38400
Example : ChangeSerialPortBaudrate 9600
Operation : Alters baud rate of serial port.
24