Table of Contents
Advertisement
4.6
Removing the front casing
A
B
1.
Use a flat-blade screwdriver to lever the seal out of the
frame for the product's rear panel.
2.
Carefully tilt the front panel towards yourself until it can
be removed from the frame.
4.7
Installing the product
1 x1
2 x3
5,5 - 6,5
C
1.
Mark the upper drill hole for the screw (1).
2.
Drill the hole.
◁
Use the supplied wall plugs and screw, provided
that these are suitable for the type of wall.
3.
Insert the screw (1) and, in doing so, ensure that it is
not screwed in completely.
0020323586_00 Installation and maintenance instructions
x3
B
4.
Mount the product on the screw (1).
5.
Align the product horizontally and mark the drill holes
for the two lower screws (2).
6.
Remove the product and drill the two lower holes.
7.
Mount the product on the screw (1) again and secure
the two lower screws (2) to the wall.
Installing the front casing
A
8.
Carefully push the front panel towards the frame until
the you hear it click into place.
5
Installation
Warning.
Risk of adverse health effects caused by
impurities in the potable water.
Sealing residues, dirt or other residues in the
pipelines may adversely affect the quality of
the potable water.
▶
Flush all of the hot and cold water pipes
thoroughly before you install the product.
Danger!
Risk of scalding and/or damage due to
incorrect installation leading to escaping
water.
Mechanical stresses in the connection cable
can cause leaks.
▶
Make sure that the connection cables are
free from mechanical stress when they
are installed.
39
Advertisement
Chapters
Table of Contents
Troubleshooting
