Troubleshooting; Environment And Recycling - Hyundai HMBE1004F Original Instruction

Troubleshooting

Problem
Motor does No electricity
not start
Defective cable
Defective safety switch/plug
combination
Overheat protection actived
Abnormal Blade is jammed
noises
Lubrication running out
Loose bolts, nuts or other
securing components
Abnormal Blades damaged or worn
vibrations
Working depth too large
Poor Working depth too small
scarification
Worn blades
results

Environment and recycling

Electrical devices do not go into the
domestic rubbish.
accessories and packaging to an
eco-friendly recycling.
According to the European Directive 2012/19/EU
on electrical and electronic scrap, electrical
devices that are no longer serviceable must be
separately collected and brought to a facility for
an environmentally compatible recycling.
Possible causes
Give devices,
Check mains connection
Check cable, plug in, replace if required, or have it
repaired by a qualified person
Arrange for repair in a specialist workshop
1. Working depth too large, set to the shorter depth
2. Blades blocked, remover the blockage
3. Soil too hard, select correct work depth and
forwards and backwards several times while slowly
down the operation speed.
wait till the motor cool down for around 15 minutes
before rework
Switch off wait till complete stop. Remove the objects
Arrange for repair in a specialist workshop
Tighten all components, contact specialist workshop if
noises prevail
Replace or have it checked by an specialist workshop
Set to correct working depth
Set to correct working depth
Replace or have it checked by an specialist workshop
Technical Data
Power supply voltage :
Power consumption :
Idle speed :
Working width :
Working depth max. :
Sound level at work-place L
Measured sound power level L
Guaranteed sound power level L
Vibration :
Weight :
18
Remedy
230V~50Hz
1000 W
380 min
360 mm
200 mm
75.4 dB(A)
PA
K = 2.5 dB(A)
88.07 dB(A)
WA
93 dB(A)
WA
0,901 m/s
K = 1.5 m/s
8.5 kg
-1
2
2