Table of Contents
Advertisement
3.4How to use
3.4.1
Start cooking
Touch the ON/OFF control.After power on, the buzzer beeps
once, timer controlshow"00"，heating zone selection controls
show ""or""or"", indicating that the induction hobhas
enteredthe state of standby mode.
Place a suitable pan on the cooking zone thatyou wish to use.
• Make sure the bottom of the pan and the surface ofthe
cooking zone are clean and dry.
Touching the heating zone selection control and an indicator
where you touched will flash.
Adjust heat setting by touching the slider control.
• If you don't choose a heat setting within 1 minute,the
Induction hob willautomatically switch off. You will need to start
again at step 1.
• You can modify the heat setting at any time duringcooking.
If the display flashesa
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minute if no suitable pan is placed on it.
3.4.2
Finish cooking
Touching the heating zone selection control that you wish to
switch off.
lternately with the heat setting
11
Advertisement
Table of Contents
