Installation Instructions - Schumacher Electric EV Series Installation And User Manual

INSTALLATION INSTRUCTIONS

CAUTION: The Schumacher Level 2 EV Wall Charger
must be installed by a licensed electrician. Any
changes to the wall charger's electrical settings (page
13) must be made by a licensed electrician.
CHOOSING A LOCATION
1. This device shall be mounted at a sufficient height from grade such
that the height of the storage means for the coupling device is
located between 600 mm (24 inches) and 1.2 m (4 feet) from grade.
2. Before starting the installation, choose a general mounting location
for the unit. The unit may be installed indoors or outdoors. Ensure
that the unit is within easy reach of where the hardwired circuit will
be installed by a licensed electrician or where there is an existing
NEMA 14-50 or NEMA 6-50 outlet. The cord or wiring leading into
the charging station should have some slack. The mounting location
should also allow the output cable with EV connector to have some
slack while in use.
3. Using a stud finder, locate a stud within the general mounting
location identified in the previous step. Use a pencil to mark the
location of the stud.
4. Next, use a level and a pencil to mark a line to designate the top of
the charging station when installation is complete. This is usually
about 50 inches above the finished floor. Use tape to attach the
mounting template so that the top edge of the template lines up
with the pencil line you just made.
- 8 -