Lock4Safe HOME2 User Instructions

ADDING THE SECONDARY CODE
1. Press and hold Key [1] until double signal.
The light remains on during the following actions.
2. Enter main code (Double signal).
3. Enter new opening code (Double signal)
Repeat new opening code (Double signal)
 In case of an entry error, wait 10 seconds and begin again.
 The new codes can be changed by the user.
 The codes must be different.
DELETING THE SECONDARY CODE
1. Press and hold Key [3] until double signal.
The light remains on during the following action.
2. Enter main code (Double signal).
SETTING TIME DELAY VALUES
1. Can only be performed with the Main Code during open period!
2. Press and hold Key [9] until double signal.
The light remains ON during the following actions.
3. Enter Main Code.
4. Enter Delay period value, from 00 to 99 minutes i.e. five (5) min
5. Enter Open Period value, from 00 to 19 minutes, i.e. two (2) min
6. Confirm values (double signal).
 00 01 minutes de-activates Time Delay
MAINTENANCE
The lock inside the door does not need maintenance; however, the boltwork of the safe
should be checked periodically by a professional, depending on the frequency of usage.
Keep the door frame area clear of items or paper that could disturb the locking
mechanism. Vacuum the bolt holes in the frame periodically to remove dust and debris.
Clean the entry unit with a damp cloth and mild soap only
 Do not spray cleaning solvent on or in the entry unit.
© 2019 www.lock4safe.com
USER INSTRUCTIONS
Electronic High Security Locks
Type HOME2
Your high security lock is produced to the highest standards. Please take a few
moments and study this manual before you begin.
The lock features a Main Code and a Secondary Code. With the main code a secondary
code and features of the lock can be activated or disabled
If not done so already, in the following table you can checkmark the features that are active
in your lock.
Active Feature Description
X
DIAGNOSTIC Always active. Allows testing the electronics of Lock
and Entry Unit.
X
MANIPULATION Always active. After input of four consecutive invalid
PROTECTION codes the keypad is blocked for 5 minutes. During this
period any key press causes a long signal. After
expiration, entry of two more invalid codes restarts the
5 minute blocking period.
TIME DELAY If active, the user must wait a determined period before
the lock can only be opened.
Make yourself familiar with the signals the lock emits.
Each key press is confirmed with an audio and light signal.
A double signal indicates that the last entry was valid 
A long beep indicates that the last entry was invalid
Safety reference:
All codes are to be securely stored. Do not use personal data (i.e. Birthdays, telephone numbers etc.)
as the code. Change the factory code before you start using the safe!
I001
EN
190114


