Operation - Daken M803994 Owner's Manual

Step One: Operate the broadcast kit
Note: See sprayer owner's manual for sprayer operating instructions
ALWAYS wear personal protective equipment as directed on the
chemical label when spraying.
Long pants and sleeves, chemical-resistant gloves, and eye protection are
strongly recommended. Additional protective gear may be required
depending on the particular pesticide.
1. Review safety
information
2. Wear personal
protective
equipment
3. Close broadcast
valve
4. Turn on power
5. Begin agitation if
needed

Operation

WARNING
Review the "Operation – Important Safety Information" related to
Chemical Application Safety and ATV Vehicle Handling Safety
provided in this manual.
Wear personal protective equipment as directed on the chemical
label.
Turn the broadcast nozzle to the off position.
OFF position
Turn on the power to the sprayer.
1.Verify the remote switch is connected to the pump power cord.
2.Turn the remote switch to the "ON" position.
Note: The pump will start automatically when power is turned on.
The pump will cycle on and off as needed to retain pressure in the
hose.
Some formulations of liquid pesticides do not remain in solution and
should be agitated to maintain a uniform mix.
An optional regulator (Item #K1032) accessory is available for use with
this sprayer and should be used when spraying pesticides classified as
"flowable" ("F" or "L"), "wettable powder" ("WP" or "W"), "emulsion"
("EC" or "E"), "microencapsulated" ("M"), or water dispersible granules
("WDG" or "DF"). (See pesticide label to determine its classification.)
Contact your vendor for any questions about the appropriate use of
the sprayer and/or optional accessories.
7