Daken M803994 Owner's Manual page 6

Step Three: Finish broadcast kit assembly
1. Remove hex plug from pump outlet.
2. Push broadcast lance into broadcast bracket. Note orientation.
3. Install hose barb into open port on pump. Hand tighten, then one turn with a wrench.
4. Connect 24" hose from pump to broadcast lance using two hose clamps. Follow hose
clamp instructions below.
5. Thread broadcast nozzle hand tight onto the end of the lance. Note orientation.
Hose clamp installation instructions
1. Slide hose clamp over the end of the hose
2. Push the hose onto the hose barb
3. Slide the hose clamp over the hose barb
4. Tighten the hose clamp
Assembly (continued)
Remove the
hex plug
Broadcast
lance
Broadcast
nozzle
Hose clamp
24" hose
Hose clamp
6
Hose barb