Operating Instructions - Skil PWRCORE 20 HD6294B-00 Owner's Manual

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach, or bleach-containing products, etc., can cause a short circuit.
WARNING
could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
This cordless hammer drill must be used only with the battery packs and chargers listed
below:
2Ah 2Ah
SKIL SKIL
BY519701 BY519702
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
To Attach/Detach Battery Pack
(Fig. 2)
Lock the trigger switch "OFF" on the tool by
placing the direction-of-rotation (forward/center-
lock/reverse) selector in the center position.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery
pack aligns with the groove in the tool and that
the latches snap into place properly. Improper
attachment of the battery pack can cause
damage to internal components.
To detach the battery pack:
Depress the battery-release button, located on the front of the battery pack, to release the
battery pack. Pull the battery pack out and remove it from the tool.
WARNING
always be locked in the center position when the tool is not in use or when carrying it at
your side .
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced . Use of this product with damaged or missing parts
Do not attempt to modify this tool or create accessories not
recommended for use with this tool . Any such alteration or modification
To prevent accidental starting that could cause serious personal injury,
always remove the battery pack from the tool when assembling parts .
Battery Pack
2.5Ah
SKIL
BY519703
Battery tools are always in operating condition . Therefore, the
direction-of-rotation (forward/center-lock/reverse) selector should
4Ah 5Ah
SKIL SKIL
BY519601 BY519603
Fig . 2
Attach
Battery-release
Buttons
Charger
SKIL
SC535801
QC536001
SKIL
QC5359B-02 SC5358B-02
i
nformation.
SKIL
SKIL
Detach
11