Troubleshooting - Husqvarna DE 110i Operator's Manual

WARNING:
center or an approved authority is permitted
to replace the HEPA filter.
WARNING:
protective equipment, refer to
protective equipment on page 15 .
WARNING:
filter are dangerous to your health.
WARNING:
no holes in the HEPA filter. A damaged
HEPA filter is a health risk.
WARNING:
filter. If you install a used HEPA filter,
Troubleshooting schedule
Problem
The motor stops immediately af-
ter start or does not start.
22
Only an approved service
Always use personal
Personal
The particles in the HEPA
Make sure that there are
Do not install a used HEPA

Troubleshooting

Cause
There is no power.
There is a fault with the battery.
The green LED flashes on the battery.
The HEPA filter is damaged or not installed.
There is a short circuit in the product.
Too high voltage in power supply.
Too high ambient temperature.
Fan is broken or disconnected.
leakage and decreased filtration efficiency
can occur.
CAUTION:
surface of the HEPA filter. This can cause
damage to the HEPA filter.
1. Loosen the 6 screws and remove the HEPA filter
cover. (Fig. 45)
2. Attach the dust cap (A) and pull out the HEPA filter.
Put it into a clean plastic bag (C). (Fig. 46)
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install a new HEPA filter. Make sure that the HEPA
filter is pushed to the end position. (Fig. 47)
5. Install the HEPA filter cover and tighten the 6
screws.
Do not touch the inner
Solution
Connect the battery to the prod-
uct.
Do a check of the battery or re-
place the battery if necessary.
Let an approved service agent
repair the product.
Low battery voltage. Charge the
battery.
Replace or install the HEPA fil-
ter.
Let an approved service agent
repair the product.
Make sure that correct power
supply is used.
Make sure that the ambient
temperature is in specified
range when you use the prod-
uct.
Let an approved service agent
repair the product.
1618 - 004 - 24.01.2022