Advertisement
Step 5
INSTALL MOUNTING POSTS TO SNOW THROWER
PARTS NEEDED
Mounting posts with 35 mm bolts (2)
L
U
U
S
S
S
S
R
R
K
S
1
R
K
L
1.1
K
Assemble the upper clamp mounting post [K] to the top plate [L] on the post on
your machine (See figure) Secure with two washers [S], two 35 mm hex bolts [U]
and two hex nuts [R].
Hand tighten. Later adjustment may be necessary to align mounting brackets
with machine.
Repeat on opposite side
3
M
Next, slide the right outer mounting post [N] into inner mounting post [M]. Repeat
on the left side by mounting part [O] on top of part [M]
Note: that you may want to adjust these connections before assembly is complete
so connections should be snug but don't have to be tight.
a r i e n s co . co m
ARIENS COMPANY, BRILLION, WI 954110, USA
S
1.2
L
U
K
L
N
M
2
Slide inner mounting post [M] onto attached upper clamp [K]. Position so that [M]
faces outward. Repeat on the other (left) side.
4
N
O
View of installed mounting posts on machine. The top section of the outer mounting
posts [O] and [N] should be vertical to the ground. Check that the posts look even,
adjust as needed.
8
TOOLS NEEDED
1/2 in. Box
Wrench
OR
Adjustable
Wrench
OR
1/2 in. Socket
Wrench
K
M
K
K
M
L
N
L
M
Advertisement
