Advertisement
Step 7
SECURE THE CAB TO SNOW THROWER ON THE [X] SUPPORT BRACKET
NOTE: Exact positioning can vary depending on your preference.
PARTS NEEDED
Y
AA
BB
CC
1
Locate the holes in the machine.
Tip: Dropping the handlebars on
the machine may make it easier to
align the holes.
L
4
K
Continue adjusting and tightening the mounting post
brackets [K] and [L] on the machine and on the cab. Keep
adjusting until bottom of the cab is level with the ground
and that it looks centered.
Adjust for best visibility, weather protection and headroom.
a r i e n s co . co m
ARIENS COMPANY, BRILLION, WI 954110, USA
Z
2
X
Align the holes in the support
bracket [X] with the holes on
the machine.
L
K
3
X
CC
BB
Y
Mount by using the 8 mm hex bolt [BB] on the top hole with split washer [CC]
and the 10 mm hex bolt [Y] on the bottom hole with washers [AA] and Nylock
Hex nut [Z] (on other side).
Tighten all bolts. Repeat on the opposite side.
Step 8
TIGHTEN ALL BOLTS
CAUTION: No part of the fabric cab skin should touch the
engine or exhaust system of your snow thrower.
Adjust for best visibility, weather protection and headroom.
10
TOOLS NEEDED
1/2 in. Box
Wrench
OR
Adjustable
Wrench
OR
1/2 in. Socket
Wrench
Z
AA
Advertisement
