Register Extra Equipment Before Auto Tuning - Bang & Olufsen BeoVision 3 Manual

Register extra equipment before
auto-tuning
If a video tape recorder, decoder or any other
extra equipment is connected to your
television, the connection is detected by the
television. You can check and confirm the
registration of the equipment involved.
CONNECTIONS
V. TAPE V. TAPE
AV DECODER
When the CONNECTIONS menu appears...
ss
> If necessary, press or
that correspond to what you have connected to
the V.TAPE socket.
> Press or to step between menu items:
▲ ▼
V.TAPE and AV.
> Press GO to store this setup.
Downloaded from ManualsNet.com
Determine the centre position
If your television is equipped with the optional
motorised stand or base, the
STAND ADJUSTMENT menu appears on the
screen. Once the centre position is determined,
select your favourite positions for when the
television is switched on and in standby.
store
GO
When the STAND ADJUSTMENT menu
tt
to select the options appears...
Make sure that there is enough room for the
television to turn to the right and left.
> Press GO to start stand adjustment.
> If the adjustment is interrupted the text
'ADJUSTMENT FAILED' appears on the screen.
Remove obstacles preventing the television from
turning, and press GO to start adjustment again.
> Once adjustment is complete, the text
'ADJUSTMENT OK' appears, followed by the
STAND POSITIONS menu.
> To store a stand position for when the television
is switched on, press
television and place it according to your viewing
position.
> To store a stand position for when the television
is switched to standby, press
TV STANDBY.
> Press
as you wish.
> Press GO to store your positions.
search engine
STAND ADJUSTMENT
CENTRE POSITION
ADJUSTING . . .
adjust GO
ss tt
or to turn the
to move to
▼
ss tt
or to turn the television and place it
NOTE! For further information about stand
positions, refer to the chapter 'Set positions for
the television to turn to' on page 36.
29