Bang & Olufsen BeoVision 3 Manual page 21

Use your pincode
If your television has been disconnected from
the mains for 15–30 minutes, the television
prompts you for the pincode when you switch
it on. If you do not enter the pincode, the
television switches to standby after
approximately 5 minutes.
PINCODE
PINCODE
MASTERCODE
MASTERCODE
Downloaded from ManualsNet.com
When your television is switched on...
> Enter the code digits using the number buttons
0 . . .
or
▲ ▼
> Press GO when the last digit is entered.
> Your television starts up again.
Five incorrect entries will cause the television to
shut down for three hours, during which
next operation is not possible.
accept
GO
Approximately 30 seconds before the system
automatically switches to standby, it cannot be
operated by remote control. Therefore, it is not
possible to enter a pincode during this time.
If you have forgotten your pincode...
> Contact a Bang & Olufsen retailer to receive a
0 . . . .
five-digit Master Code.
> When the television prompts you for your
pincode, press and hold
MASTERCODE menu.
> Entering the code digits using the number
buttons or
your pincode and reactivate your television.
next
accept
GO
search engine
.
ss
to bring up the
and pressing GO will deactivate
▲ ▼
21