Advertisement
Operating:
Round button to
change light modes
Charging - 10-12 hours charging time:
Connect the charger lead into the socket and connect the charger into a power supply (AC or DC),
depending on the charger being used.
How to reset pulsars:
• Removing all pulsars from the carry case
• Switching them all OFF, pushing and holding the round button
• Once they are all switched off, on ONE pulsar only push and hold the square button for approximately 30 seconds, a red and
amber LED will flash inside the unit
• For each other pulsar now push and hold the square button for approximately 30 seconds (one unit at a time) the red and amber
LED's will flash for a short time and go off, repeat this for the entire set. (the original pulsar will continue to flash during the process)
• Once all units have been reprogrammed, press the square button on the original (first pulsar). The red amber LEDs will now
go off, release the button and set pulsar to one side
• Replace pulsars into carrying case, they should now operate correctly
THE WILL-BURT COMPANY
401 Collins Blvd., Orrville, OH USA 44667
Telephone: +1 330 684 4000
Email: info@willburt.com
Square button to
change colour modes
Note: The pulsar lights will not turn off until they are replaced back into the case.
Charging Indicator:
Red light = charging in process | Green light = fully charged
One you have finished using the pulsar's fold the case back on itself so the pulsars
are held in the case securely.
Warning: Never use the charger if the leads, contacts or casings are
damaged. Do not use any chargers other than those provided.
• Remove pulsars from the charging case and place on the ground, an amber
light will appear and the pulsar will start flashing. Lay the remaining pulsar
on the ground and they will the automatically synchronise with the flashing
mode of the previous pulsar.
• The buttons on any of the pulsar can be pressed to change the colour
modes and 6 flashing modes.
• Press the round button to change between the 6 flashing modes.
• Press the square button to change between the colour modes
- blue/amber/red.
• When you have the pulsars set up to the chosen flashing and colour mode,
place all Pulsars back into the pockets in the carry case, ensuring the
magnet is face down and the cluster of 4 LEDS is face up. The Pulsar are
held inside of the pocket by the magnet. Now they are ready to be charged.
All NightSearcher products have a 3-year standard
warranty on all manufacturing defects and 1-year warranty
on all rechargeable batteries from the date of purchase.
Product weight
Product size
NS Part No.
2106822.6 Patent Pending
5kg
370x150x335mm
5838301
Advertisement
