Table of Contents
Advertisement
Quick Links
DogCare WELL-D LE Dog Training Collar (Model: TC08) FAQ's
1. Can't turn on Remote.
a.
Please make sure the remote is charged. Plug the charging cable into the port at the
bottom of the remote and the other end into a working power outlet. Charging should
take about 2 to 3 hours. (It is suggested to charge only for 2 to 3 hours to preserve longer
battery life).
b. After charging, twist the intensity dial clockwise. The dial can be found on the front top
right of the remote. The LED light will briefly flash green.
c. To turn off, align the power icon with the status LED light.
2. Can't turn on the Receiver.
a. Please make sure the Receiver (collar) is charged. Plug the charging cable into the port at
the bottom side of the receiver and the other end into a working power outlet. Charging
should take about 2 to 3 hours. (It is suggested to charge only for 2 to 3 hours to preserve
longer battery life).
b.
Press and hold the ON / OFF button on the top of the Receiver until the collar makes a
double beep and vibrates (press it hard).
3. The Receiver/Collar does not respond.
a. Make sure the receiver and the remote are both charged and have enough power.
b. Make sure the receiver and remote have been paired. (See #4).
c. Check if both units are turned ON.
d. If you have more than one (1) receiver/collar, make sure that the receiver is on the
corresponding channel. (Test the different channels if necessary by changing the channel
with the button on the right and pressing the beep or vibrate button to confirm. Re-pair if
necessary).
e. Press the beep or the vibrate button to test if the receiver is responding. (To test the
shock see # (7) below).
4. How to "Pair" the Receiver/Collar with the Remote Control.
a. The remote and receiver have been paired at the factory. Channel Display is "1".
i. To start, make sure the Receiver/Collar is turned OFF. To turn it OFF press and
hold the ON/OFF button on the top of the collar until it beeps and the indicator
will flash a red light.
WELL-D LE
Dog Training Collar
(Model: TC08)
Advertisement
Table of Contents
Related Manuals for Dog Care WELL-D LE TC08
Summary of Contents for Dog Care WELL-D LE TC08
- Page 1 WELL-D LE Dog Training Collar (Model: TC08) DogCare WELL-D LE Dog Training Collar (Model: TC08) FAQ’s 1. Can’t turn on Remote. Please make sure the remote is charged. Plug the charging cable into the port at the bottom of the remote and the other end into a working power outlet. Charging should take about 2 to 3 hours.
- Page 2 ii. Make sure the remote is turned ON. Twist the intensity dial clockwise. The dial can be found on the front top right of the remote. The LED light will briefly flash green. iii. Press and hold the ON/OFF button on the collar until the light “quickly” flashes green.
- Page 3 e. You can also slightly wet the area as water helps to conduct the electric static. 9. There is a delay between when I push the orange shock button and when the shock happens. a. When the battery is low there may be a delay with the shock function. Make sure the remote and receiver are fully charged.
- Page 4 rice for 8-hours. These actions may help with waterproof function. Training 1. Use verbal commands first. Supplement with a corrective stimulus only as needed. 2. Be consistent with your verbal commands, using the same word(s) every time. 3. Work with your pet on one behavior at a time to avoid confusion or frustration. 4.
Need help?
Do you have a question about the WELL-D LE TC08 and is the answer not in the manual?
Questions and answers