Operating The Gira Homeserver; Programming A Gira Homeserver; Firmware Update; Programming The Gira Homeserver - Gira HomeServer Installation Instructions Manual

Table of Contents

Advertisement

Operating the Gira HomeServer

3.
Operating the Gira HomeServer
3.1

Programming a Gira HomeServer

With the HS Expert software, the Gira HomeServer is individually programmed to the user's
requirements. In order to be able to use the program quickly and to its full extent, Gira offers
(online) training (https://akademie.gira.de/).
There are also sample projects that can be found on your PC when the HS Expert is installed.
Further sample projects are available for download on the http://download.gira.de website.
3.2

Firmware update

The firmware should be updated before programming the Gira HomeServer for the first time:
1. Start the "HS Expert" software.
2. Open the menu item: "HomeServer/Upload firmware".
3. The firmware can be transferred to the Gira HomeServer via LAN or via a USB stick.
4. For transfer via LAN: Enter the IP address of your device.
With version 4.11 and higher, you can determine the IP address using the "Find device"
function (button next to the IP address).
5. Transfer the firmware.
For initial start-up, the login data is
User: admin
Password: admin
The Gira HomeServer restarts and reports with 3 double signal tones after operational read-
iness.
To find out which version of the firmware is on the device, you can call up the debug page
(see "URLs and ports" below): https://HSIP/hsinfo or (for version 4.11 and higher) https://
HSIP/.
If access via LAN is not possible, you can connect a keyboard and monitor to the device and
read the IP address from the screen.
3.2.1

Programming the Gira HomeServer

1. Start the "HS Expert".
2. Open a sample project.
3. Set DHCP (for version 4.11 and higher) or an IP address in the network settings.
4. Assign a password to every user.
5. In the menu item "Transfer", the project is transferred to the Gira HomeServer.
6. Transfer the project to the Gira HomeServer.
For initial start-up, the login data is
User: admin
Password: admin
The Gira HomeServer restarts and then indicates its operational readiness with three double
signal tones.
12
11.2020/V 2.3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Facilityserver052900207500

Table of Contents