Safety Information General Observe all warnings that appear in this manual. This system is not intended to be used for treating water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Keep the unit in the upright position.
Safety Information (Cont.) Location Selection Location of a water treatment system is important. The following conditions are required: Level platform or floor. Total minimum pipe run to water heater of ten feet (three meters) to prevent backup of hot water into system. ...
The other end of the hose runs to a drain and is secured in place. 5. Manual valve shall be installed at the inlet/outlet of the MPC-1054-FV or MPS-1054-FV system. A bypass valve is recommended to be installed between the inlet and outlet of the system so that normal usage of water is not affected during the maintenance of the system.
Drain line connection Note: Standard commercial practices are expressed here. Local codes may require changes to the following suggestions. Check with local authorities before installing a system. 1. The unit should be above and not more than 20 feet (6.1 m) from the drain. Use an appropriate adapter fitting to connect 1-inch plastic tubing to the drain line connection of the control valve.
Warranty Terms and Conditions This product is warranted to be free from defects in material and workmanship for a period of one (1) year from the date of purchase*. This warranty is for does not cover accessories subject to wear and tear during usage (seals, o-ring, etc). *PROOF OF PURCHASE REQUIRED The unit must be used in operating conditions that conform to PEN K’s recommended design guidelines.
Activated Carbon** 20 L 1,720.00 ** For model MPC-1054-FV, it uses Activated Carbon 40 liter. Model : MPS-1054-FV In case the media have expired or deteriorated, please inquiries or purchases through the company's service. The prices shown in the table below are as follows:...
Need help?
Do you have a question about the MPC-1054-FV and is the answer not in the manual?
Questions and answers