Symbol
Function
Unstable. The symbol appears when the weight value is not stable. The weight value
can be read as soon as it is stable. Functions like tare, zeroing, printing or summing are
possible only with a stable weight value.
Zeroing. The scale is in zero position.
Weight unit. The weight unit is shown at the right of the display. Possible weight
indications are kg, g, lb. and oz.
Net weight. The display shows the net weight.
Gross weight. The display shows the gross weight.
Weighing range. Display of the weighing range of the multiple range scale.
Piece counting mode. The display shows the value as a set.
Total. The display shows the stored cumulative value in both the weighing and
counting modes.
Average piece weight. The display shows the average piece weight.
Gross/Net. Preliminary gross weight display.
Battery charge level indicator. Displays the battery charge status. During charging, the
status indicator moves.
Battery empty level indicator. Indicates that the batteries are almost empty and must be
charged immediately.
Operation of the indicator with attached weighbridge
Switching on
Press
key. The indicator starts the automatic function test and displays "0" at the end. The scale is
now ready for weighing.
Switching off
Switch the indicator off by holding down the
Automatic power off
The indicator has an automatic shutdown function. Depending on the selected setting, the automatic
shutdown is deactivated or it takes place when the scale is not used after 1, 2, 3, 4 or 5 minutes. The
setting is made via the configuration menu.
Weighing mode
Place the item to be weighed on the platform. If the scale is unstable, the display shows
scale is stable, the symbol disappears and the display shows the weight applied.
If a weight is displayed in spite of an empty weighing platform, perform manual zeroing by pressing the
key. Once the scale is in zero position, the display shows
7
3.
Function
key for approx. two seconds.
.
STAN07-210324-Rev005-UM-en
. Once the
Need help?
Do you have a question about the STAN07 and is the answer not in the manual?