Parts And Features - Craftsman Bolt-On 35592 Operator's Manual

When using an extension cord, be sure to
use one heavy enough to carry the current
your product will draw. An undersized
cord will cause a drop in line voltage
resulting in loss of power and overheating.
The following table shows the correct
size to use depending on cord length and
nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the
gauge number, the heavier the cord.
Safety Warnings and Instructions
WARNING:
To reduce the risk of serious personal injury, read, understand and follow all
safety warnings and instructions prior to using tool.

PARTS AND feATUReS

1. Power Unit
2. Forward/reverse slider
3. Variable speed trigger
4
3
OPeRATING: POWeR UNIT
TRIGGeR SWITCh & fORWARD/ReveRSe SlIDeR
The Power Unit's (1) forward/reverse slider (2) is used to control the direction the chuck (6) spins:
Forward to drive screws; Reverse to remove screws. It is located above the variable speed trigger (3).
After any operations, return lever to the forward position. Never change the direction of rotation while
the motor is running.
• The Power Unit is turned ON and OFF by pulling and releasing the trigger. The more the trigger is
pulled, the higher the speed of the Power Unit.
• A forward/reverse control slider determines the direction of the tool.
• To select forward rotation, release the trigger switch and depress the forward/reverse control
button to the left.
volts
120V
240V
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more
Than Than
0 -
6 -
10 -
12 -
SAve TheSe INSTRUCTIONS
ReAD All INSTRUCTIONS
4. Attachment release button
5. Drill attachment
6. Keyless chuck
1
2
Minimum Gauge for Cord Sets
Total length of Cord in feet
0-25 26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50 51-100
American Wire Gauge
6 18 16
10 18 16
12 16 16
16 14 12
7. Torque adjustment collar
6
5
51-100 101-150
101-200 201-300
16 14
14 12
14 12
Not Recommended
7
5