LG F2T1TNM0W Owner's Manual page 41

FAULT
Excessive foam is
formed in the detergent
drawer.
Unsatisfactory washing
result.
Unsatisfactory washing
result.
As soon as the machine
is loaded with water,
water discharges.
No water appears in the
drum during washing.
Laundry has
detergent residue.
Grey spots appear on
the laundry.
The spin cycle does not
take place or takes place
later than expected.
(*) See the chapter regarding maintenance and cleaning of your
machine.
(**) See the chapter regarding installation of your machine.
POSSIBLE CAUSE
Excessive amount of
detergent used.
Wrong detergent used.
Your washing is too dirty for
the programme selected.
Amount of detergent used
insufficient.
There is too much laundry in
your machine.
Hard water.
Your laundry is too tightly
packed together in the drum.
The end of water drain hose is
too low for the machine.
No fault. Water is in the
unseen part of the drum.
Non-dissolving particles of
some detergents may appear
on your laundry as white
spots.
There is untreated oil, cream
or ointment on your laundry.
No fault. The Unbalanced
load control system has been
activated.
EN - 37
TROUBLESHOOTING
Press the Start/Pause button. To stop the
foam, dilute one tablespoon of softener
into 1/2 litre of water and pour into the
detergent drawer. Press the Start/Pause
button after 5-10 mins.
Only use detergents produced for
automatic Washing Machines.
Use the information in the programme
tables to select the most appropriate
programme.
Use the amount of detergent as instructed
on the packaging.
Check that the maximum capacity for
the selected programme has not been
exceeded.
Increase the amount of detergent following
the manufacturer's instructions.
Check that your laundry is spread out.
Check that the drain hose is at a suitable
height. (**) .
. . . . . . . . . . . . . . . . . . . . .
Perform an extra rinse, or clean your
laundry with a brush after it dries.
Use the amount of detergent as instructed
on the packaging in the next wash.
The Unbalanced load control system will
try to spread your laundry. The spinning
cycle will begin once your laundry is
spread. Load the drum evenly for the next
wash.