Water Discharge Connection; Control Panel Overview - LG F2T1TNM0W Owner's Manual

• To prevent water leaks at
the joints, either 1 or 2 nuts
(depending on your machine's
specifications) are supplied in
the packaging with the hose.
Fit these nuts to the end(s)
of the water inlet hose that
connect to the water supply.
2. Connect new water inlet
hoses to a ¾ ˝, threaded tap.
• Connect the white capped
end of the water inlet hose to
the white water inlet valve on
the rear side of the machine
and the red capped end of
the hose to the red water inlet
valve (if applicable).
• Hand tighten the connections.
If in any doubt, consult a
qualified plumber.
• Water flow with pressure
of 0. 1-1 Mpa will allow
your machine to operate at
optimum efficiency (pressure
of 0. 1 Mpa means that more
than 8 litres of water per
minute will flow through a fully
opened tap).
3. Once you have made all of
the connections, carefully
turn the water supply on and
check for leaks.
4. Ensure that the new water
inlet hoses are not trapped,
kinked, twisted, folded or
crushed.
• If your machine has a hot
water inlet connection, the
temperature of the hot water
supply should not be higher
than 70°C.
NOTE:
Machine must only be connected
to your water supply using the
supplied new fill hose. Old hoses
must not be reused.
3.5 Water Discharge
Connection
• Connect the water drain hose
to a standpipe or to the outlet
elbow of a household sink,
using additional equipment.
• Never attempt to extend the
water drain hose.
• Do not put the water drain
hose from your machine into a
container, bucket or bathtub.
• Make sure that the water
drain hose is not bent,
buckled, crushed or extended.
• The water drain hose must be
installed at a maximum height
of 100 cm from the ground.
4. CONTROL PANEL
OVERVIEW
1
EN - 13 EN - 13
Your Washing
2 3